Skip to content
Heat pumps sized room by room (339) 300-1805
HVAC Financing Lynn logo
Row of blue gas burner flames inside a furnace

Leaving oil and gas behind

Lynn Oil & Gas Heating Replacement

Your worn-out boiler or furnace, replaced by a heat pump that keeps you toasty in winter and comfortable in summer.

When the Old Burner Is on Its Last Legs

An oil boiler patched up year after year, a furnace that groans awake every morning, a propane tank that always seems to run dry at the worst time. Eventually, fixing it just doesn't add up. Swapping in a heat pump changes more than what fuel you buy. You end up with one system for winter warmth and summer cooling alike, so the window units and the oil truck can both become old stories. HVAC Financing Lynn takes care of the whole switch. We measure the house so the heat pump is sized to its real heat loss, plan how warmth reaches each room and decide together what happens to the old equipment. In any zone the heat pump now handles, the old burner there is hauled away or permanently disconnected. Want a safety net instead? With integrated controls, the heat pump does nearly all the work and the old burner only wakes up in deep cold. Which way you go affects which Mass Save rebate applies, so we'll explain the difference before you choose. When the project qualifies, the 0% HEAT Loan can help pay for the switch.

Pieces of a Replacement Job

Changing heating systems involves more than a straight swap. Here's what we manage.

  • Sizing from heat loss

    The heat pump is matched to your house, not to the label on the old burner.

  • Getting heat to every room

    Ducted, ductless or a mix, depending on how warmth needs to travel through the house.

  • Hauling out the old unit

    Boilers, furnaces and their odds and ends taken out or shut off when the heat pump steps in.

  • Backup that waits its turn

    If the old system stays, it's wired so it only runs during deep cold.

  • Rebate route explained

    How removal or backup changes the Mass Save rebate, laid out before you decide.

  • 0% loan paperwork

    Proposal and forms prepared when the HEAT Loan is part of the plan.

  • Startup and a tour

    Testing in heating and cooling modes, then a clear rundown of the new controls.

How the Switch Unfolds

  1. Size up old and new

    We take a look at your boiler or furnace, the radiators or vents and the electrical panel, and talk through whether you want backup heat to stay.

  2. Put the plan in writing

    You get the design, the plan for the old unit, the price, a rebate estimate and the loan amount, all on paper.

  3. Out with the old

    Your heat pump goes in, and the old burner is hauled off, disconnected for good or hooked to integrated controls. We test it all and wrap up the paperwork.

Folks Make the Switch With Us Because

  • Straight talk on backup

    You'll hear the trade-offs of pulling versus keeping the old system before you choose.

  • Program rules, followed

    The old system is handled the way the rebate expects, so nothing puts it at risk.

  • Comfort in every season

    Your new system cools too, so the upgrade earns its keep in summer as well.

  • Sized from heat loss
  • Old unit dealt with
  • Backup controls
  • Summer cooling too

Is Your Boiler or Furnace Running on Fumes?

Tell us how old it is, what it burns and what's been acting up. We'll explain how a heat pump replacement would work in your house.